![]() ![]() ![]() Derek Bas, recently patented a new tunable RF filter design that can replace the currently used YIG (yttrium iron garnet) based device. Working toward the aim of developing game-changing RF technology, Air Force Research Laboratory scientists led by Dr. The typical difficulties of making smaller mechanical and physical components, however, are dwarfed by the challenges posed by making the required onboard electronic equipment smaller, lighter, and less power-hungry. As the RF Isolator will add some amount of insertion loss and product reflections of its own (non-ideal VSWR), this must also be taken into consideration when selecting an isolator.WRIGHT-PATTERSON AIR FORCE BASE, Ohio (AFRL) – As the Department of the Air Force continues with the unrelenting pursuit of driving down the size, weight and power of radio frequency (RF) components, the inherent challenges in these types of technologies are compounded. It is important to select an RF Isolator that matches the signal chain requirements, such as frequency range and power. RF Isolators can be used to protect any component or section of a signal chain from reverse reflections, but are most often used to protect active devices, such as transceivers, power amplifiers (PAs), low-noise amplifiers (LNAs), and mixers. Reverse power continuous-wave and/or peak (dB).Forward power handling continuous-wave and/or peak (dB).The isolation of an RF Isolator is directly related to the quality of the match of the termination. ![]() It is also likely that pre-manufactured RF Isolators will be more compact and plug-and-play compared to a RF Isolator made from an off-the-shelf RF Circulator. However, factory designed RF Isolators will likely have much better matched terminations and are designed and tested to operate over the entire frequency range and to the specified power levels. It is possible to make an RF Isolator from an RF Circulator by just terminating the reverse port. With a well matched termination on the reverse port, the majority of the reflected/reverse signal energy from the output port will be directed to the termination and dissipated and heat. It is critical for an RF Isolator to have a well matched termination in the reverse port to optimize the isolation. RF Circulators/RF Isolators are typically passive ferrite devices that are made in such a way that the internal magnetic fields within the component steer the electromagnetic waves incident at the ports in a certain direction, with these waves exciting at the nearest port in the direction of travel.Īs the name implies, RF Isolators are predominately used to isolate upstream signal chain components, which are typically more sensitive components, from reflections from downstream components. This modification of RF Isolators only allows for signal energy to pass in the forward direction, in reference to the signal chain, and heavily “isolates” the upstream signal chain from any reverse reflections or noise/interference injection. RF Isolators are specific cases of RF Circulators where one of the three ports, typically the reverse port in reference to the signal chain, is terminated. ![]()
0 Comments
Leave a Reply. |